JLCooper FaderMaster Pro - Manual (Page 30)

➤ Assigning Merge Modes
To view or change the merge assignment for a given fader, first
make sure you are in PROG Mode, and the Fader LED is on
steadily (not flashing.)
Press MERGE. The display will show one of the following:
0n = Merge On.
All data is passed through FaderMaster Pro and merged with
fader data.
0FF = Merge Off.
Data coming into FaderMaster Pro is examined. If the fader is
set to Merge Off, and if Controller data comes into FaderMaster
Pro with the same Parameter Number and MIDI channel that
the fader is set for, that data is not passed through.
[on = Conditional Merge.
The data coming into FaderMaster Pro is examined as
described above. Merging takes place until the corresponding
fader is moved. At that point the data coming in is not passed
through, but is replaced by fader data. A momentary push of
SHIFT and PROG button allows MIDI data to be merged again.
In the User Programmable Banks P1 through P20, you set the
merge for each fader by pushing the MERGE button and
moving the fader.
To exit the programming mode, press the PROG button again
until both LEDs are off.
30