JLCooper FaderMaster Pro - Manual (Page 11)

MERGE
In the P Banks, in Program Mode, hold Merge while moving a
fader to select the Merge mode for that fader.
Each fader within a bank may have a different Merge mode.
Merge On: MIDI commands pass through FaderMaster Pro.
Merge Off: MIDI coming into FaderMaster Pro is checked
to see if any fader is programmed to send out the same
commands. MIDI passes through FaderMaster Pro, unless a
fader is programmmed to send the same commands.
Merge Conditional: MIDI commands pass through
FaderMaster Pro. MIDI coming into FaderMaster Pro is
checked to see if any fader is programmed to send out the
same commands.
The MIDI data is allowed to pass through to the MIDI out,
until you move a fader. Then, that MIDI data is selectively
filtered out. This is used to replace previously recorded
tracks of MIDI data.
SNAP (that is, SHIFT and MERGE)
Holding the SHIFT button and pressing SNAP sends out a
“Snapshot” consisting of MIDI data representing the current
position of the faders.
Used at the beginning of a sequence to establish the initial
levels of a mix.
NULL LEDS (Used With Automation Bank)
Compares the position of the last fader moved with the value
of MIDI data coming into the FaderMaster’s Pro’s MIDI input.
Lets the user know if the fader is above (up arrow) or below
(down arrow) the level of the MIDI data coming into
FaderMaster Pro.
Used to assist in seamless punch in type edits of previously
recorded MIDI data for mix editing.
11