JLCooper FaderMaster Pro - Manual (Page 31)

Programming the Buttons
To program the buttons, press the PROG button until the
BUTTON LED is lit.
Programming a button is easy.
But it is not immediately obvious.
(One might be inclined to ask the question, "how do you
program the buttons, since the buttons themselves are used for
selecting the parameters and attributes of the buttons?")
Here is the answer: The buttons are programmed exactly like
the faders are programmed. You select which button you are
programming by moving the fader under the button.
A Simple Example
To make button 1 send MIDI Controller 7 with a value of 0
when pressed,
❏ Enter BUTTON programming mode by pressing the
PROG button until the BUTTON LED is lit.
❏ Move fader 1 while holding the PARM button
until
[o is displayed.
❏ Move fader 1 while holding the PARM# button
until
7 is displayed.
❏ Exit BUTTON program mode by pressing the PROG
button until both LEDs are not lit.
Now, pressing button 1 will send a MIDI Controller 7 with a
value of 0 when pressed. Since MIDI Controller 7 is MIDI
volume, pressing the button will act as an audio mute.
Remember, you choose the button number that you want to
program by moving the corresponding fader below the button.
31