JLCooper FaderMaster Pro - Manual (Page 61)

Factory Preset Banks F1
through F59
There are 59 Factory Preset Banks. These have been pre-
programmed to allow FaderMaster Pro to function as a remote
controller for specific instruments. These presets are designed
to facilitate both programming and real-time control.
We have also included a Preset Card listing what each bank
does, for quick reference.
Selecting the Factory Preset Banks
The 59 programs in the Factory Bank are designated F1
through F59. While holding the UP or DOWN button you may
rapidly go to the desired preset by moving any fader.
These presets are stored in FaderMaster Pro’s internal EPROM,
and are not user-changeable. The exception to this is that
certain instruments have the ability to set a Sysex Device
Number. FaderMaster Pro allows for this, in that the presets for
those instruments may have their channel number changed.
This is useful if you are controlling more than one of the same
kind of device.
Refer to the listing below to determine if a given instrument
allows a Device Number to be user-selected. This is indicated
by “*”. When allowable, setting the MIDI channel for any fader
sets the Sysex device number for all eight faders. These
changes will be saved in the battery-backed memory.
In the Factory Preset banks, the Fader Attributes (Speed, Min
and Max, etc.) are preset, and the Merge and Group do not
operate.
Remember that FaderMaster Pro’s output may be recorded
onto a MIDI sequencer. The sequencer can then provide
automated playback of your parameter changes.
61