JLCooper FaderMaster Pro - Manual (Page 33)

Programming the Foot Pedal
The foot pedal input accommodates a user-supplied foot
pedal. (Most pedals with tip-ring-sleeve plugs will work.)
A Foot Pedal is programmed just like the faders.
It is programmed in Foot Pedal Program mode, which is
selected by pressing the PROG button until the FADER LED
flashes.
In Foot Pedal Program mode, select the desired parameter or
attribute button while moving fader 1.
Exit Foot Pedal Program mode by pressing the PROG button
until both LEDs are not lit.
Programming the Foot Switch
The foot switch input accommodates a user-supplied
momentary foot switch.
Both "normally open" and "normally closed" type foot switches
will work. Plug in the foot switch before powering on
FaderMaster Pro, so the internal microprocessor has the
opportunity to "look at" the foot switch to determine which
kind it is.
The foot switch is programmed in Foot Switch Program mode,
which is selected by pressing the PROG button until the
BUTTON LED flashes.
In Foot Switch Program mode, select the desired parameter or
attribute button while moving fader 1.
33