JLCooper FaderMaster Pro - Manual (Page 32)

Here is how to set the various parameters and attributes of the
buttons, in the P banks and in Button programming mode:
➤ PARM
Hold the PARM button while moving a fader to select whether
the button will send Notes (
No), Controllers ([o), Program
Change ( PG), Pitch Bend (PB). Notice that Notes are always
sent as Note On, Note Off pairs with each button press.
➤ CHAN
Hold the CHAN button while moving a fader to select what
MIDI channel the button will send on, 1 through 16.
➤ PARM#
Hold the PARM# button while moving a fader to select what
Controller Number or Note Number the button will send, if the
button has been assigned to send Controllers or Notes.
➤ MIN
Hold the MIN button while moving a fader to select the
minimum value that the button will send.
➤ MAX
Hold the MAX button while moving a fader to select the
maximum value that the button will send.
➤ SPEED/BM (BUTTON MODE)
Hold the SPEED/BM button while moving a fader to select
whether the button’s action is
- - - Momentary
Button sends MIN value when pressed and MAX value
when released.
L [ K Latched
Button sends MIN value when pressed.
Button sends MAX value when pressed again.
F A d Uses Fader Value
Button sends MIN value when pressed. Sends value equal
to fader position when pressed again.
(Group and Merge are not assignable to the buttons.)
32