JLCooper FaderMaster Pro - Manual (Page 40)

Setting Bank Limit
To set the Bank Limit in the Automation Banks,
press UP or DOWN until the desired highest Automation Bank
is displayed, and keep the button pressed.
While holding the button , press the other bank select button.
For example, to set the Bank Limit to A 3,
❏ Select A 1 Display says A 1
❏ Press UP Display says A 2
❏ Press UP again and do not release it
Display says A 3
❏ Press DOWN.
❏ Release both buttons. Display says A 3.
While the Bank Limit is set, there is a decimal point LED in the
A banks, in this case
A 1. A 2. A 3.
Escaping from the Bank Limit
Even after setting a Bank Limit, you can still select any
FaderMaster Pro Bank, by holding either UP or DOWN while
moving a fader. So you can use the P banks P 1 through P 20,
the F Banks, even A banks outside the limit.
But the LIMIT is stored in memory, until you choose to remove
it. For whenever you select a Bank within the range of the
limit, pressing UP or DOWN again returns you to cyclic
stepping through only the limited automation banks.
To completely turn off the Bank Limit:
Press DOWN and UP at the same time and observe that the
decimal point LED turns off as you release both buttons.
40