JLCooper FaderMaster Pro - Manual (Page 44)

To Program the Automation Bank,
➤ Select Automation Bank number A 1.
Use the UP or DOWN buttons to step to the desired program
number, or, hold UP or DOWN while moving any fader and
stop moving the fader when the desired number is reached.
➤ Press the PROG button once so that the FADER LED is lit.
You will notice that in the Automation Bank, the PROG button
toggles the FADER LED on or off. There is no separate
BUTTON mode.
Example
To make all the faders send sequential controller numbers on
MIDI channel 5, starting with Controller number 10:
❏ Move fader 1 while holding the PARM# button until 10 is
displayed.
❏ Move fader 1 while holding the CHAN button until 5 is
displayed.
❏ Exit the Fader Program mode by pressing PROG once
again so that the FADER LED is out.
Now, when Bank A 1 is selected, the faders send the following
MIDI commands:
Fader 1
Controller 10, channel 5.
Fader 2 Controller 11, channel 5.
Fader 3 Controller 12, channel 5.
Fader 4 Controller 13, channel 5.
Fader 5 Controller 14, channel 5.
Fader 6 Controller 15, channel 5.
Fader 7 Controller 16, channel 5.
Fader 8 Controller 17, channel 5.
44