JLCooper FaderMaster Pro - Manual (Page 21)

Programming the Faders (In Detail)
Here are the specifics parameters and attributes that may be
selected for each fader. (Remember that these settings may
only be reviewed and edited in Fader Program mode.)
➤ PARM
Hold the PARM button while moving a fader to select whether
the fader will send Notes (
No), Controllers ([o), Program
Change ( P[), After Touch (At) or Pitch Bend (Pb).
➤ CHAN
Hold the CHAN button while moving a fader to select what
MIDI channel the fader will send on, 1 through 16.
➤ PARM#
Hold the PARM# button while moving a fader to select the
what Controller Number or Note Number the fader will send, if
the fader has been assigned to send Controllers or Notes.
➤ MIN
Hold the MIN button while moving a fader to select the
minimum value that the fader will send when it is moved to the
bottom of its travel.
➤ MAX
Hold the MAX button while moving a fader to select the
maximum value that the fader will send when it is moved to
the top of its travel.
Notice
If you set a faders minimum value higher than its
maximum value, the fader will operate reversed.
21