JLCooper FaderMaster Pro - Manual (Page 58)

Program the First Fader
Remember that in the Automation Bank you need only assign
the first fader a MIDI controller number and MIDI channel.
Check that Protect is OFF. (SHIFT PROTECT)
❏ Enter Program Mode by pressing PROG and noting that
the FADER LED is lit.
❏ Hold the CHAN button while moving fader 1 to select
the MIDI channel.
❏ Hold the PARM# button while moving fader 1 to set the
starting controller number.
Often with multiple-port, multiple channel computer MIDI
interfaces, FaderMaster Pro’s settings can be arbitrary.
Just set the first fader for Controller #0 on MIDI channel 1.
❏ Exit Program Mode by pressing the PROG button again
so that the FADER LED is not lit.
Consider the Hookup
The first time you write fader moves (that is, record controller
data) will be called the first automation “pass”. It is only
necessary to have a single MIDI cable from the output of
FaderMaster Pro to the input of the sequencer or digital audio
workstation. The sequencer’s “Thru” may be on.
On subsequent passes, when it comes time to edit previously
recorded MIDI controller data, a cable must be connected from
the output of the sequencer to the input of FaderMaster Pro.
The sequencer’s “Thru” should be off.
Refer to the section on page 45 for strategies on how to avoid
loops.
58