JLCooper FaderMaster Pro - Manual (Page 45)

When Bank A 2 is selected, the faders send the following MIDI
commands:
Fader 1 Controller 18, channel 5.
Fader 2 Controller 19, channel 5.
Fader 3 Controller 20, channel 5.
Fader 4 Controller 21, channel 5.
Fader 5 Controller 22, channel 5.
Fader 6 Controller 23, channel 5.
Fader 7 Controller 24, channel 5.
Fader 8 Controller 25, channel 5.
Again, we restate that moving the faders will not send any
MIDI data at all until the faders are “Write Enabled” by pressing
the button above the fader. (This is explained in detail on the
next page.)
The Mute buttons above the faders send the same controller
number as the faders.
They send a 0 value when pressed, and the LED turns on.
They send a value equal to the fader when they are pressed
again, and the LED turns off.
About the Foot Pedal
In the Automation Banks, the Foot Pedal sends the same kind
of MIDI data that the faders send. 64 is added to the controller
or note number of the first fader.
In other words, the pedal acts like a 65th fader.
About the Foot Switch
In the Automation Banks, the Foot Switch sends the same kind
of MIDI data that the faders send. 65 is added to the controller
or note number of the first fader. The switch is momentary,
sending a fixed maximum value (127) when depressed, and a
fixed minimum value (0) when released.
45