Important information – Gasboy FiPay Payment Network User Manual
Page 24
Installing FiPay (NBS)
Page 24
MDE-4999A FiPay™ Payment Network Installation and Setup Instructions · October 2012
Note: If you had selected NOT to back up your existing installation, then you will see the
following message and the installation process will terminate (see
Figure 25: Alert Message
5
After the configuration has been applied, the HASP key driver installation will begin. Press
any key to continue the installation process.
6
The script will then copy the driver files for the HASP to your computer and make the required
configuration changes to your computer for it to operate. At this point, you will see the
following two messages (see
). The first message indicates that the driver is being
loaded and second message indicates that the operation has been successfully completed.
Figure 26: Operation Successful Message
(i)
(ii)
The HASP key does not have to be inserted for the drivers to be successfully installed.
However, it must be inserted before FiPay service will start and function.
IMPORTANT INFORMATION
7
Press any key to complete the software installation.
8
To complete the installation and start the FiPay service, refer to
on