Initialize current nbs configuration (-i), Editing network parameters (-e) – Gasboy CFN Series NBS User Manual
Page 19
MDE-4390F Gasboy CFN Series NBS (GL3) Credit and Debit Card Network V 1.3.0.0 · November 2008
Page 15
NBS Command
Using NBS
Initialize Current NBS Configuration (-I)
Use this option at the beginning of site setup (
) or if you need to return to the default
values. If you are using this command to restore default values, you should perform a
settlement first (refer to
). This option resets all router values
to defaults by erasing whatever changes have been entered. The data tables affected are the
card and network parameters, product cross-reference, and host-response strings. These table
items will need to be re-entered. Reboot the Site Controller when the editing is complete.
1
To initialize, type NBS -I.
2
Type Y at the prompt. The following message appears:
Initialize NBS (Merchant info will be lost)? [y/n].
Editing Network Parameters (-E)
The NBS program allows you to edit parameters by entering their number, which is shown on
the menu. When you run NBS -E, a menu of parameters appears on the screen. A sample is
shown below.
Note: The screen will have different parameter settings.
Gasboy International Site Controller III
Financial Network Setup
NBS (1.2.2.0)
NETWORK PARAMETERS
1. Initialization type : NBS Host
2. Main Bank Phone Number : 15558881078
3. Backup Bank Phone Number : 15558881077
4. Carrier wait timeout : 20
5. Verification timeout : 95
6. Terminal ID : GB1028123456602
7. Pre-auth mode : 2
8. Use Modem Pre-dial : Enabled
9. Maximum hours allowed in a fallback condition : 0
Enter Item Number, W-Walkthrough Edit, RETURN-Next Page, Q-
Quit, At any time press ? for help :
Note: Terminal ID is case-sensitive. Ensure that the Terminal accurately represents the
information provided by the host company.