Gasboy CFN Series NBS - Manual (Page 17)

MDE-4390F Gasboy CFN Series NBS (GL3) Credit and Debit Card Network V 1.3.0.0 · November 2008 Page 13
NBS Command Using NBS
4 – Using NBS
NBS Command
The NBS command prompts you for each item of information that is needed. The program
also checks data and warns you when errors occur and prompts you on how they can be fixed.
The program can be run in the following ways:
• using the menu
• using the command line (full command set)
Menu
To run NBS in the menu mode, proceed as follows:
1 Type NBS. The NBS Main Menu appears.
NBS MAIN MENU
1. Initialize Network Parameters
2. Edit Network Parameters
3. Edit Card Parameters
4. Edit Modem Parameters
5. Edit Product Cross Reference
6. Print System Configuration
7. Remove Transaction from Batch
8. Read Network Parameters from File
9. Write Network Parameters to File
10. View Fallback Lapse Time Information
Output to: SCREEN
Enter Menu Number, F-File, S-Screen, ?-Help, Q-Quit
2 Enter the number to the left of an item, to execute that item. The “F”, “S”, and “?” options
allow you to:
• F - redirect all screen output to a specific file.
Note: When redirecting screen output, prompts will not be displayed; instead, they are
redirected to the file. Use this option carefully to avoid introducing errors.
• S - route the output to the screen.
• ? - enable the help options.
By default, the output is displayed on the screen.
3 After you complete these settings, select Q to exit.