Gasboy CFN Series NBS - Manual (Page 18)

Using NBS NBS Command
Page 14 MDE-4390F Gasboy CFN Series NBS (GL3) Credit and Debit Card Network V 1.3.0.0 · November 2008
Command Line
The command line format of the program is NBS option[s] where the valid options are as
follows:
Symbol Description
-I Initialize Network Parameters
-E Edit Network Parameters
-C Edit Card Parameters
-M Edit Modem Parameters
-X Edit Product Cross References
-S Print System Configuration
-D Remove Transaction from Batch
-R Read Network Parameters from File
-W Write Network Parameters to File
-G<0/1> Disable(0)/Enable(1) Bank Cards at the Island
-F Displays Fallback Lapse Time Information
-? Displays these valid options as listed above
The options can be combined, though care must be taken in combining some operations with
the read, write, and initialize file options. The program acts upon the FRAMOS.CFG file in
the current directory. Each of the options are discussed below in this manual.
Saving Parameter Changes
To save any changes you make with the NBS options, select Quit and select Yes when
prompted to save changes. The program stores the information in FRAMOS.CFG and/or in the
router tables.
Note: If you do not select Yes, all the information that you have entered will be lost.
The program then runs a check on all the NBS-related parameters. Some parameters cannot be
edited within this program, but the appropriate program is mentioned if a problem occurs. A
message will be displayed that tells you which of the parameters is in error. Reboot the site to
load the new configuration.
Diagnostics
Checking SYS_PAR...
Checking READER...
Checking TABLES
No errors detected