Fluke Biomedical TNT 12000 - Manual (Page 94)

TNT 12000
Users Manual
4-4
6. When the Device Upgrade window in the PC display shows the upgrade is
successful, click on the Exit button. The Detector starts automatically after the
download.
Display
1. Double-click the downloaded executable file for the Display.
2. When the Device Validation window shows, connect the Display to the PC
through the Mini-B to Type-A USB cable.
3. Push O on the Display.
4. When the upgrade button on the Device Validation window is activated, click the
Upgrade button.
5. While the firmware downloads to the Display, a progress bar in a Device Upgrade
window shows in the PC display. LEDs on the Display blink while date moves to the
Display.
Note
Do not click on the close button in the upper-right hand corner of the
Device Upgrade window during the download. This will abort the
download.
6. When the Device Upgrade window in the PC display shows the upgrade is
successful, click on the Exit button. The Display starts automatically after the
download.
Service and Calibration
If repair or calibration becomes necessary, send the TNT 12000 to the factory or nearest
service center. Always contact the Fluke Biomedical Service Center for a Return
Authorization Number before you pack the TNT 12000 for shipment.
Packing
When you return the TNT 12000 to the factory or service center, provide the following
information.
• Serial numbers
• Specific steps that reproduce the problem
• Daytime phone number
• Your name / company
• FAX number, if available
Carefully put the TNT 12000 in the shipping container supplied by Fluke Biomedical. If
the container the TNT 12000 came in is not available, refer to the Return Procedure at the
front of this manual. You can get a replacement shipping container from Fluke
Biomedical through their web site.
Note
Failure to pack the TNT 12000 properly could void the warranty.
Shipping
Before shipping the TNT 12000:
1. Place the Return Authorization Number in a prominent place on the outside of the
box. Always refer to the number in any correspondence with Fluke Biomedical.
2. Enclose your return address and Return Authorization Number.
3. Insure the shipment for full retail value.
4. Ship to the nearest Fluke Biomedical Service Center.