Fluke Biomedical TNT 12000 - Manual (Page 4)

Repair and calibration:
To find the nearest service center, go to
www.flukebiomedical.com/service , or
In the U.S.A.:
Cleveland Calibration Lab
Tel: 1-800-850-4606 ext. 2564
Email: [email protected]
Everett Calibration Lab
Tel: 1-888-993-5853
Email: [email protected]
In Europe:
Eindhoven Calibration Lab
Tel: +31-402-675300
Email: [email protected]
Certification
This instrument was thoroughly tested and inspected. It was found to meet Fluke Biomedical’s manufacturing specifications when it
was shipped from the factory. Calibration measurements are traceable to the National Institute of Standards and Technology (NIST).
Devices for which there are no NIST calibration standards are measured against in-house performance standards using accepted test
procedures.
WARNING
Unauthorized user modifications or application beyond the published specifications may result in electrical shock hazards or
improper operation. Fluke Biomedical will not be responsible for any injuries sustained due to unauthorized equipment
modifications.
Restrictions and Liabilities
Information in this document is subject to change and does not represent a commitment by Fluke Biomedical. Changes made
to the information in this document will be incorporated in new editions of the publication. No responsibility is assumed by
Fluke Biomedical for the use or reliability of software or equipment that is not supplied by Fluke Biomedical, or by its
affiliated dealers.
Manufacturing Location
The TNT 12000 X-Ray Test device is manufactured in Cleveland, Ohio by Fluke
Biomedical, 6045 Cochran Rd., Cleveland, OH, U.S.A.