Fluke Biomedical TNT 12000 - Manual (Page 79)

Microsoft Excel Add-In Software
Introduction
3
3-3
Introduction
The Microsoft Excel Add-In Software (hereafter the Add-In) emulates the TNT 12000
Display. You can set Detector parameters and collect measurement data through the PC
to Detector connection. Waveform download is an added function that is not available
through the Display. The kV data measured by the Detector is downloaded to the Add-In
and placed in a worksheet. The data points are then plotted using the Microsoft Excel
graph feature.
System Requirements
The Add-In must be loaded onto a PC with the following hardware and software:
• Microsoft Windows 2000, Windows XP, or Windows Vista operating system.
• Microsoft Excel 2000 or higher
• One USB port
• CD-ROM disk drive
Communication between the PC and a Detector is through a wireless (ZigBee) or wired
(USB) connection.
How to Install the Add-In
Installation involves installing the Excel Add-In software and a Vendor Class driver.
How to Install the Excel Add-In Software
To install the Excel Add-In software:
1. Start the PC.
2. Put the TNT 12000 X-ray Test Tools CD in the CD-ROM drive. The installation
starts automatically. If not, browse to the CD-ROM and double-click on launch.exe
to start the installation.
3. After the CD-ROM program starts, click on the “Install Excel Add-In” button.
4. When the InstallShield Wizard screen shown in Figure 3-1 shows, click on Next.
fct301.bmp
Figure 3-1. InstallShield Wizard