Fluke Biomedical TNT 12000 - Manual (Page 72)

TNT 12000
Users Manual
2-44
Setup Options
The setup options for the TNT 12000 lets you connect Detectors to the Display, set the
power settings, and set the date and time clock. When the Setup button is highlighted
and E is pushed, the SETUP screen in Figure 2-21 shows in the Display.
fct13.bmp
Figure 2-21. Setup Screen
If the mAs Detector is connected to the Display, a setup button for a Shunt or Clamp is
added as shown in Figure 2-22. See the How to Use the mAs Detector section to use the
clamp or shunt for this measurement.
fct18.bmp
Figure 2-22. Setup Screen from mAs Measurement
If the DoseMate Detector is connected to the Display, a setup button for T & P Sensor
Adj and Status are added as shown in Figure 2-23. See the How to Use the Dosimeter
Detector section for information on these two selections.