Comtech EF Data XSAT-7080 - Manual (Page 3)

Filename: T_ERRATA
1
Errata A
Comtech EFData Documentation Update
Subject: Revised Pin lable for Connector J3
Date: February 12, 2007
Part Number: MN/XSAT7080.IOM
Related Document: XSAT-7080, X-Band Transceivers Installation and Operation
Manual, Rev. 0 dated October 21, 2005
Collating Instructions: Attach this errata sheet to the cover.
Comments:
The highlighted change revises the connector pinout label.
Change Specifics:
3.1.1 C ONNECTOR J3: AC P OWER , M AINS , 100 TO 125 VAC, OR
205 TO 240 VAC.
WARNING
To avoid a serious shock hazard, correctly determine the mating
connector type in use and wire it according to the following table:
EARLY UNITS NEWER UNITS
Pin Mating Connector Type
KPT06J12-3S
MS3116J12-3S Mating Connector Type
CA3106E18-22SB
A Line Ground
B Ground Neutral
Labeled
C or G Neutral Line