Comtech EF Data XSAT-7080 - Manual (Page 27)

3–1
Chapter 3. SYSTEM OPERATION
This section contains instructions for operating the XSAT-7080, X-Band Transceiver.
The Primary customer interface to the XSAT is via the Remote Communications port.
Chapter 4 provides details regarding the protocol and command/response structure used
on this interface. This chapter will define in detail the controllable parameters provided
via the command/response structure.
3.1 P
IN
-
OUTS
3.1.1 C
ONNECTOR
J3: AC P
OWER
, M
AINS
, 100
TO
125 VAC,
OR
205
TO
240 VAC.
WARNING
To avoid a serious shock hazard, correctly determine the mating
connector type in use and wire it according to the following table:
Early Units Later Units
Pin Mating Connector Type
KPT06J12-3S
MS3116J12-3S
Mating Connector Type
CA3106E18-22SB
A Line Ground
B Ground Neutral
C Neutral Line