Comtech EF Data XSAT-7080 - Manual (Page 132)

XSAT7080 X-Band Transceiver Revision 0
50 and 100-Watt Installation MN/XSAT7080.IOM
B–22
B.6.2.2 A
SSEMBLE
R
EDUNDANT
C
ONFIGURATION
Step Procedures
1 Place Unistrut bracket (1, Figure B-1) on a flat surface. (see Figure B-19.)
2
Slide two springnuts (9) into the channel of the Unistrut bracket.
3 Fasten two pipe blocks (11) loosely to the springnuts using two bolts (6), two
flat washers (7), and two splitlock washers (8).
4 Repeat procedure for second Unistrut bracket (1)
5 Position Unistrut bracket (1) with pipe blocks (11) against the mounting pole,
slide the pipe blocks (11) until they contact the mounting pole. (see Figure
B-20.)
6 Ensure the pipe blocks (11) are centered to the Unistrut brackets (1). (see
Figure B-21.)
7 Tighten the hardware.
Figure B-19. Preparing the Pole Bracket