beautypg.com

Dot Hill Systems II 200 FC User Manual

Page 26

background image

1-6

SANnet II 200 FC, SATA, and SATA SE Array Installation, Operation, and Service Manual • March 2005

Caution –

In FC and SATA configurations with large drive capacities, the size of the

logical drive might exceed the device capacity limitation of your operating system. Be
sure to check the device capacity limitation of your operating system before creating
the logical drive. If the logical drive size exceeds the capacity limitation, you must
partition the logical drive.

Note –

For information about the maximum usable storage capacity for the

SANnet II 200 FC, SATA, and SATA SE arrays, refer to the SANnet II 200 FC and
SATA Array Best Practices Manual
.

1.1.3

SANnet II 200 FC, SATA, and SATA SE Array
Configurations

The FC, SATA, and SATA SE arrays can be used in the following configurations:

Single-controller configuration. A RAID array can be configured with a single
controller in a non-redundant configuration.

A RAID array with two controllers. A RAID array can be configured with two
controllers to provide full redundancy.

An expansion unit. An expansion unit consists of a chassis with disk drives and I/O
expansion modules. The expansion unit does not include an I/O controller module.
The expansion unit connects to and is managed by a RAID array. The SANnet II
200 SATA Special Edition (SE) does not support expansion units.

A Just a Bunch of Disks (JBOD) array. The JBOD array connects to, and is
managed by, a host server. Only the SANnet II 200 FC JBOD is supported.

See Appendix B for detailed information about using SANnet II 200 FC JBOD arrays.

Maximum
Number of
Disks per
Configuration

192 (1 RAID array +
15 expansion units)

192 (1 RAID array + 15
expansion units)

12 (1 RAID array)

Maximum
Number of
Logical
Drives

32 logical drives

32 logical drives

32 logical drives

Direct host-
attached
JBOD
Support

One JBOD per server

Not supported

Not supported

Table 1-1 Comparison of SANnet II 200 FC, SATA, and SATA SE Array Features (Continued)

SANnet II 200 FC Array

SANnet II 200 SATA Array

SANnet II 200 SATA SE Array