Dot Hill Systems II 200 FC User Manual

Page 189

Appendix H Configuring an IBM Server Running the AIX Operating System H-3

Figure H-1 RAID Array COM Port Connected Locally to the Serial Port of a Host

System

2. Power on the array.

3. After the array is powered up, power on the IBM server and log in as

root

, or become

superuser

if you are currently logged in as a user.

4. Start the Kermit program and set the parameters as shown.

Use the device-specific name for the serial port you are using. In the example, the
serial port being configured is

/dev/tty0p1

Note –

To return to the Kermit prompt type Ctrl \ and then C. To exit Kermit, first

return to the Kermit prompt and then type

exit

# kermit

Executing /usr/share/lib/kermit/ckermit.ini for UNIX...

Good Morning!

C-Kermit 7.0.197, 8 Feb 2000, for HP-UX 11.00

Trustees of Columbia University in the City of New York.

Type ? or HELP for help.

(/) C-Kermit>set line /dev/tty0p1

(/) C-Kermit>set baud 38400

/dev/tty0p1, 38400 bps

(/) C-Kermit>set term byte 8

(/) C-Kermit>set carrier-watch off

(/) C-Kermit>C

Connecting to /dev/tty0p1, speed 38400.

The escape character is Ctrl-\ (ASCII 28, FS)

Type the escape character followed by C to get back,

or followed by ? to see other options.

----------------------------------------------------

COM port