Updating embedded firmware – Basler Electric BE2000E User Manual
Page 64

56
9287500995 Rev B
A new password can be programmed by performing the following steps:
1.
Click Communications on the menu bar and click Password Change on the drop-down menu. The
Change Password dialog box of Figure 39 appears.
2.
Type the current password in the "Enter your access password" field of the Change Password
dialog box and press the Enter key on your keyboard.
3.
Another dialog box will appear with instructions for making the password change. Click the OK
button and type a new password (8 alphanumeric characters, maximum) in the "Enter your new
password" field.
4.
Press the Enter or Tab key on your keyboard to advance the cursor into the field labeled "Re-
enter your new password". Type the new password again to confirm the changed password and
press the Enter key. When the Enter key is pressed, the new password is enabled and a dialog
box appears to remind you to keep your password in a secure location.
Figure 39. Password Dialog Box
Updating Embedded Firmware
The BE2000E uses non-volatile flash memory for storing its embedded firmware (operating program) and
can be reprogrammed by connecting the RS-232 port, located on the on the back of the device, to a
Windows
® compatible PC running the Embedded Program Loader software. It is not necessary to
physically replace EPROM chips to update the program.
The process of updating the embedded firmware can be started by clicking BE2000ELoad on the menu
bar and clicking Uploading Embedded Software. A warning window, Figure 40, will be displayed. The
BE2000E should be disconnected from the generator and bus before continuing with this procedure and
the current settings file should be backed up since uploading may replace some settings with defaults.
Clicking No will cancel this procedure.
Figure 40. Embedded Software Uploading
BESTCOMS
™ Software
BE2000E