Basler Electric BE2000E - Manual (Page 44)

36 9287500995 Rev B
Changing Settings
Caution
Do not disconnect the communications cable while the BE2000E and
PC are communicating.
Settings are arranged into six groups:
•
System Configuration
•
Setting Adjustments
•
Control Gain
•
Analysis
•
Protection Settings
•
Metering, Operation, and Alarms
Note
BESTCOMS-BE2000E may display the dialog box of Figure 19 when
initializing BE2000E communication, obtaining BE2000E configuration
settings or performing other tasks. It’s important to wait until the box
disappears before trying to execute communication commands.
Issuing commands while the Wait dialog box is present may disrupt
communication between BESTCOMS-BE2000E and the BE2000E.
Figure 19. Wait Dialog Box
Each setting group has a corresponding button that can be selected to access that group of settings. The
six setting groups can also be accessed by clicking Screens on the menu bar and then selecting the
desired setting group from the list. Once a setting group is accessed, the individual settings of the group
can be viewed and changed.
A setting is changed by clicking within the setting field and typing the new setting. The range limit of a
setting can be viewed by double-clicking the setting. Any setting changes made on a setting group screen
must be sent to the BE2000E before viewing other screens. Otherwise, the setting changes will be lost. A
single setting change can be sent to the BE2000E by pressing the Enter key on your PC keyboard.
Multiple setting changes can be sent to the BE2000E by clicking the SendToUnit button. Settings can
also be sent to the BE2000E by clicking Communications on the menu bar and clicking Send To Unit.
Sending and Receiving Settings
When communication is enabled, BE2000E settings can be sent or received through BESTCOMS-
BE2000E.
Sending Settings
Settings changes are sent to the BE2000E by clicking the SendToUnit button. This causes the settings
displayed on the current settings screen to become the BE2000E settings. Settings can also be sent to
the BE2000E by clicking Communications on the menu bar and clicking Send To Unit. Individual setting
BESTCOMS
™ Software
BE2000E