Axel AX3000 65 User's Manual - firmware 0632 - Manual (Page 86)

Using the AX3000
72
AX3000 - User's Manual
a) Copy
From a Windows Session (RDP or ICA):
Use the standard 'Copy' function. For example
From a VNC Session:
The 'vncconfig' tool must be run. The copy is simply done by selecting a text
zone.
From a Text Session (5250, 3270, ANSI, VT...):
Press (with 5250 and 3270 emulations) or (with
other emulations) to enter the Copy mode. Use the mouse to select the copy
data. Pressing validates the selection and the text is copied into a local
clipboard. ( cancels Copy Mode).
Note: the Copy function is available only if the mouse is supported by the
current session.
b) Paste
To Windows Session (RDP or ICA):
Use the standard 'Paste' function. For example
To a VNC Session:
The 'vncconfig' tool must be run. Select 'Paste' in the contextual menu of the
Linux software.
To a Text Session (5250, 3270, ANSI, VT, WYSE...):
Press (with 5250 and 3270 emulations) or (with
other emulations) to paste the contents of the local clipboard.
Note: for the 5250 and 3270 sessions, a function is sent at the end
of each line contained in the clipboard.
4.6 - TURNING OFF THE AX3000
A careful check should be made before turning off the TCP/IP AX3000 if TCP/IP
connections are active. The operating system cannot detect if a TCP/IP device