Axel AX3000 65 User's Manual - firmware 0632 - Manual (Page 167)

Installing under OS/390
AX3000 - User's Manual
153
To set the Prt3270 service, enter the AX3000 Set-Up and select
[Configuration]-[Aux. Ports]-[xxx].
In the displayed box, set the "Associated Service" to "Prt3270", then select "Net
Service Parameters" and press . The following box is displayed:
These parameters are:
- Server: the server to which the AX3000 opens a printer connection
(press to get a list of available servers).
This parameter must be entered.
- TCP PORT: telnet port of the S/390 server. Default is 23.
- LU Name: system printer name.
- Auto-Connection: set to yes.
- Auto-Reconnection: set to yes.
- Enhanced parameters: see Appendix A.10.3.
- Pre-print String: character string sent before the printing.
- Post-print String: character string sent after an the printing (for example
"\0C" is a form feed)
Note: if the auxiliary port used for printing is a serial port, set the 'Printer'
operating mode and set the associated parameters (baud rate, handshake, etc).
7.4 - REMOTE ADMINISTRATION
7.4.1 - Remote Control
This functionality allows an administrator to remotely take control of a terminal.