Axel AX3000 65 User's Manual - firmware 0632 - Manual (Page 45)

Interactive Set-Up
AX3000 - User's Manual
31
To configure the server table, select the [Configuration]-[TCP/IP]-[Servers]
menu. A dialog box as shown below is displayed:
The server definition depends on whether or not DNS is enabled (see Chapter
3.1.2):
- No DNS: a server is identified by both an alphanumeric character string
beginning with a letter AND an IP address.
- With DNS: a server is defined only by its name. This name can be either
a full name (www.axel.com) or an incomplete name (as400). Its IP
address is resolved later. (See Appendix A.4)
Add a Server: move the highlight cursor to a vacant line and enter the name
and either its IP address or DNS name.
Delete a Server: select the server and press [DELETE].
Change a Server: move the highlight cursor over the name or IP address of the
server and enter the new value.
Note: the default DNS domains, previously defined through the DNS box are
displayed for information (they can not be modified).
3.1.4 - Router Management
A router is either a special electronic device, or a suitably configured computer,