Axel AX3000 65 User's Manual - firmware 0632 User Manual
Page 232
Remote Administration
218
AX3000 - User's Manual
Solution:
check the number of sessions and pages.
ERR 214: Associate host not found. Association reset.
Command:
setup_send
Cause:
a session is associated with a non existing host.
Consequence: to get a consistent configuration, this session is not
associated with a host.
Solution:
check the host configuration.
ERR 215: s%_udk_xxx and following: no place to store udk value.
Command:
setup_send
Cause:
not enough memory to store a group of programmable keys.
Consequence: the default values of these keys are restored.
ERR 218: Telnet service and default port conflict.
Command:
setup_send
Cause:
the telnet set-up TCP port is in conflict with another service.
Consequence: the telnet set-up doesn't work properly.
Solution:
the conflict must be fixed.
ERR 219: ASCIItoEBCDIC: only on default port.
Command:
setup_send
Cause:
The ASCII to EBCDIC operating mode is not associate with
the default port.
Consequence: the auxiliary port doesn't work properly.
Solution:
change the default auxiliary port.
ERR 221: Service and RDP redirection conflict.
Command:
setup_send
Cause:
an auxiliary port is used by both the RDP redirection and by
a network service.
Consequence: the auxiliary port doesn't work properly.
Solution:
the conflict must be fixed.