Axel AX3000 65 User's Manual - firmware 0632 - Manual (Page 80)

Using the AX3000
66
AX3000 - User's Manual
This chapter covers use of the AX3000.
4.1 - TURNING ON THE AX3000
The following operations are performed when the terminal is turned-on:
- Boot: initialisation, network detection...
- Auto-configuration (optional): checks over the network if a new
firmware/configuration is available. If yes the terminal reboots again for
the new firmware/configuration to take effect (for more information see
Chapter 2.2)
- Auto-Connection: some connections may be opened automatically:
- Screen sessions (if the 'auto-connection' parameter is set to 'yes'),
- Auxiliary port sessions: if the associated service is a client service
(tty, telnet or prt5250) and if the 'auto-connection' parameter is set
to 'yes'.
If multiple screen sessions are auto-connected, the first active screen
session is displayed.
- Session Manager: if no screen session is connected, the Session
Manager is displayed (see Chapter 3.2.3). Two modes are available:
- Classic mode
- Desktop mode
The following chapter covers the session manager modes.