Avery Dennison Monarch 9855 Programmer Manual - Manual (Page 54)

9-2 NCL Programmer’s Manual
Use the following syntax to upload a log file. For the recommended file
sequence of sections in an NCL file, see “NCL File Sequence” in
Chapter 1.
Syntax [NCL_START]
[Log]
Keys=values
[NCL_END]
Keys Description Values
IPAddr IP address of the file transfer
server
nnn.nnn.nnn.nnn
FTP_User User name for file transfer
server
"“username"
FTP_Password Password for file transfer server "password"
Path Relative path to where the log
file will be written
"sub-directory\filename"
Clear Sets a flag to clear the data
before starting the next NCL file 1 clears the buffer
If FTP_User and FTP_Password are provided, the FTP protocol is used;
otherwise, the file transfer is done via TFTP protocol.
Additionally, the Path can contain the constants listed in Chapter 1. See
"Using Constants" for more information.
Example
[NCL_START]
[Log]
IPAddr=10.20.30.40
Path="Log\MyLog.txt"
Clear=1
[NCL_END]
This NCL file contains a log section [Log]. The IP Address of the TFTP
server is 10.20.30.40. The log file is named Mylog.txt and located
in the Log directory. Then, the log buffer is flagged for clearing, but the
data remains in the printer's log until the start of the next NCL file.
No log file is sent if the printer errors.