beautypg.com

Avery Dennison Monarch 9855 Programmer Manual User Manual

Page 21

background image

Configuring the Network 3-3

Keys

Description

Values or Select ONE of the following:

Speed

Sets the wireless speed

11 | 5.5 | 2 | 1

APDensity

Sets the access point’s density

Low | Med | High

Auth

Sets the authentication value
Note: When disabling WEP, set the

authentication to OPEN.

Open | Shared | TTLS | LEAP | PEAP |

WPA-PSK

CmdStr

Sends the quoted string directly to the network
card. This allows data to pass directly through the

printer to the network card. Do not use SHOW or

HELP commands.

"your command here"

Enc

Sets the encryption mode

Disabled | 64 | 128 | WPA | WPA2 |

WPA2-WPA | Dynamic WEP

InAP

Sets the EAP inner authentication protocol

PAP | MSCHAP_V2

Cert

Sets the EAP certificate, which is too long to enter

on one line. Use at the beginning of

the certificate and at the end of the
certificate.

See “Note”

CertCN1

Sets the EAP common name. If no value is set

(null), all host certificates are accepted.

63 characters

CertCN2

Sets the second EAP common name. If no value is
set (null), all host certificates are accepted.

63 characters

CertExp

Sets the EAP certificate exponent value

nnnnn

(5 digits)

CertKey

Sets the EAP root key value

See “Note”

ID

Sets the authentication user ID

63 characters

PW

Sets the password for 802.11b/g EAP

authentication

63 characters

WPAAuto

Sets whether to use WPA auto mode (use WPA
and/or non-WPA access points)

EN | DI

WPAGroup

Sets whether to use the WPA group key mode

EN | DI

WPAPSK

Sets the WPA pre-shared key or pass-phrase

nnnnnnnnnnn

64 hex characters
For a pass-phrase, it must be between

8 and 63 displayable characters.

Note:

Refer to the Telnet commands chapter in the MonarchNet2
Operating Instructions
for more information.

This manual is related to the following products: