Avery Dennison Monarch 9855 Programmer Manual - Manual (Page 15)

Configuring the Printer 2-1
C O N F I G U R I N G T H E P R I N T E R
Use the syntax provided in this chapter to write the printer-specific
section of an NCL file.
Refer to the printer’s Operator’s Handbook for more information about
each option. For the recommended file sequence of sections in an NCL
file, see “NCL File Sequence” in Chapter 1.
Note: You do not have to include every Key in the NCL file unless you
want to change it from the current value. The Keys can be listed
in any order, but they are processed in the order received.
Syntax [NCL_START]
[Printer.nnnn]
Keys=values
[NCL_END]
Keys Description Select ONE of the following:
SupplyType Selects the supply type Aperture | Die Cut | Black Mark |
Continuous
Ribbon Selects the ribbon or energy No | Yes | High Energy
Speed Selects the print speed in inches
per second (IPS) 2.5 IPS | 4.0 IPS | 6.0 IPS |
8.0 IPS | 10.0 IPS | 12.0 IPS | Default
FeedMode Selects the feed mode Continuous | On-Demand
Backfeed Enables backfeed mode Off | On | Extended
PrintPosition Adjusts where data prints vertically
on supply -450 to 450
SupplyPosition Adjusts the printer to print at 0,0
point
0 to 300
MarginPosition Adjusts where data prints
horizontally on supply -99 to 99
CutPosition Adjusts where the tag is cut -300 to 300
DispensePosition Adjusts the stopping point of label 50 to 200
BackfeedDistance Amount to move label backwards 10 to 200
2