Avery Dennison Monarch 9855 Programmer Manual - Manual (Page 20)

3-2 NCL Programmer’s Manual
Keys Description Select ONE of the following:
Router Sets the router/gateway address nnn.nnn.nnn.nnn
CmdStr Sends the quoted string directly to the network card. This
allows data to pass directly through the printer to the
network card. Do not use SHOW or HELP commands.
"your command here"
Example [NCL_START]
[NIC.TCPIP.7411BG]
Boot=4
Method=BOOTP
CmdStr="SET PRN REL POR S2"
[NCL_END]
This NCL file sets the number of Boot tries to 4 and the device receives
its IP address via a BOOTP server. It also sets the Monarch
® Smart
Relay
™ port to serial port 2 (enables the Smart Relay system).
W i r e l e s s S e t t i n g s
For the recommended file sequence of sections in an NCL file, see “NCL
File Sequence” in Chapter 1.
Syntax [NCL_START]
[NIC.EN.7411BG]
Keys=values
[NCL_END]
Note: EN is the only valid section name for wireless settings.
Keys
Description Values or Select ONE of the following:
Mode Sets the 802.11b/g wireless mode Infastruct | Adhoc
SSID Sets the 802.11b/g wireless SSID or network name nnnnnnnnnnnnnn
Up to 14 alphanumeric characters,
enclose in quotes ("") if using a space
WEP Sets the Wired Equivalent Privacy encryption
Note: Your access point may show 40-bit instead of
64-bit, but they are the same.
Disabled | 64-bit | 128-bit
ActiveKey Sets which WEP key number is used 1 to 4
KeyVal Sets the WEP key value for the current ActiveKey;
entered in Hex nnnnnnnnnn
10 digits for 64-bit WEP (or 40-bit)
nnnnnnnnnnnnnnnnnnnnnnnnnn
26 digits for 128-bit WEP (or 104-bit)