Avery Dennison Monarch 9855 Programmer Manual - Manual (Page 50)

8-6 NCL Programmer’s Manual
Use the following syntax to update the printer’s firmware and the network
card’s firmware. For the recommended file sequence of sections in an
NCL file, see “NCL File Sequence” in Chapter 1.
Syntax [NCL_START]
[Firmware.7411BG]
Keys=values
[NCL_END]
Note: Using version 5.4 or greater software, use .7411BG as the
section name. With previous software versions, use .7411 as
the section name.
The Version must be specified before the Path.
Print test labels or a network label to determine the wording for
the version strings.
Keys Description Values
IPAddr IP address of the network’s server that
handles printer firmware nnn.nnn.nnn.nnn
PrnBootVer Compares the printer’s bootloader version on
the server with the current printer’s
bootloader version.
VERSION N.N
PrnBootPath Relative path to the printer’s bootloader
(.BIN) file. If the versions do not match, the
printer
♦ requests the file be sent from the file
server.
♦ goes into “load mode” to wait for the file.
♦ resets.
"sub-directory\filename"
PrnAppVer Compares the firmware version on the server
with the current printer’s firmware version.
Version N.N
PrnAppPath Relative path to the printer’s firmware (.BIN)
file. If the versions do not match, the printer
♦ requests the file be sent from the file
server.
♦ goes into “load mode” to wait for the file.
♦ resets.
"sub-directory\filename"