Artesyn MVME6100 Single Board Computer Installation and Use (June 2014) - Manual (Page 81)

Pin Assignments
MVME6100 Single Board Computer Installation and Use (6806800D58H) 81
5.2.2 Gigabit Ethernet Connectors (J9, J93)
Access to the dual Gigabit Ethernet is provided by two transpower RJ-45 connectors with
integrated magnetics and LEDs located on the front panel of the MVME6100. The pin
assignments for these connectors are as follows:
Pin 2-9 on the connector is connected to PHY BCM5421S.
DS1 and DS2 signals are controlled by the on-board Reset PLD.
5.2.3 PCI Mezzanine Card (PMC) Connectors (J11 – J14, J21 – J24)
There are eight 64-pin SMT connectors on the MVME6100 to provide 32/64-bit PCI interfaces
and P2 I/O for two optional add-on PMCs.
PMC slot connectors J14 and J24 contain the signals that go to VME P2 I/O rows A, C, D, and Z.
Table 5-2 Gigabit Ethernet Connectors (J9, J93) Pin Assignment
Pin # Signal 1000 Mb/s 10/100 Mb/s
1 CT_BOARD +2.5V +2.5V
2 MDIO0+ B1_DA+
1
TD+
3 MDIO0- B1_DA- TD-
4 MDIO1+ B1_DB+ RD+
5 MDIO1- B1_DC+ Not Used
6 MDIO2+ B1-DC- Not Used
7 MDIO2- B1_DB- RD-
8 MDIO3+ B1_DD+ Not Used
9 MDIO3- B1_DD- Not Used
10 CT_CONNECTOR GNDC GNDC
DS1 LED1A PHY_10_100_LINK_L 2 PHY_10_100_LINK_L
DS2 LED1B PHY_1000_LINK_L PHY_1000_LINK_L
DS3 LED2A PHY_XMT_L PHY_XMT_L
DS4 LED2B PHY_RCV_L PHY_RCV_L