4 getting started, 1 overview of startup procedures, 2 unpacking guidelines – Artesyn MVME6100 Single Board Computer Installation and Use (June 2014) User Manual
Page 20: Table 1-1, Startup overview, Hardware preparation and installation
Hardware Preparation and Installation
MVME6100 Single Board Computer Installation and Use (6806800D58H)
20
1.4
Getting Started
This section provides an overview of the steps necessary to install and power up the
MVME6100 and a brief section on unpacking and ESD precautions.
1.4.1
Overview of Startup Procedures
The following table lists the things you will need to do before you can use this board and tells
where to find the information you need to perform each step. Be sure to read this entire
chapter, including all Caution and Warning notes, before you begin.
1.4.2
Unpacking Guidelines
Unpack the equipment from the shipping carton. Refer to the packing list and verify that all
items are present. Save the packing material for storing and reshipping of equipment.
Table 1-1 Startup Overview
What you need to do...
Refer to...
Unpack the hardware.
Configure the hardware by setting jumpers on the board.
Install the MVME6100 board in a chassis.
Connect any other equipment you will be using
Verify the hardware is installed.