Artesyn MVME6100 Single Board Computer Installation and Use (June 2014) - Manual (Page 37)

MOTLoad Firmware
MVME6100 Single Board Computer Installation and Use (6806800D58H) 37
Most MOTLoad tests can be organized to execute as a group of related tests (a testSuite)
through the use of the testSuite command. The expert operator can customize their
testing by defining and creating a custom testSuite(s). The list of built-in and user-defined
MOTLoad testSuites, and their test contents, can be obtained by entering testSuite -d at
the MOTLoad prompt. All testSuites that are included as part of a product specific MOTLoad
firmware package are product specific. For more information, refer to the testSuite
command description page in the MOTLoad Firmware Package User’s Manual.
Test results and test status are obtained through the testStatus, errorDisplay, and
taskActive
commands. Refer to the appropriate command description page in the
MOTLoad Firmware Package User’s Manual for more information.
3.3.3 Command List
The following table provides a list of all current MOTLoad commands. Products supported by
MOTLoad may or may not employ the full command set. Typing help at the MOTLoad
command prompt will display all commands supported by MOTLoad for a given product.
For a detailed description of these commands refer to the MOTLoad Firmware Package User’s
Manual.
Table 3-1 MOTLoad Commands
Command Description
as One-Line Instruction Assembler
bcb
bch
bcw Block Compare Byte/Halfword/Word
bdTempShow Display Current Board Temperature
bfb
bfh
bfw Block Fill Byte/Halfword/Word
blkCp Block Copy
blkFmt Block Format
blkRd Block Read
blkShow Block Show Device Configuration Data