Artesyn MVME6100 Single Board Computer Installation and Use (June 2014) - Manual (Page 31)

Hardware Preparation and Installation
MVME6100 Single Board Computer Installation and Use (6806800D58H) 31
Figure 1-2 on page 23 shows the locations of the various connectors while Table 1-5 lists them
for you. Refer to Chapter 5, Pin Assignments for the pin assignments of the connectors listed
below.
1.8 Completing the Installation
Verify that hardware is installed and the power/peripheral cables connected are appropriate for
your system configuration.
Replace the chassis or system cover, reconnect the system to the AC or DC power source, and
turn the equipment power on.
Table 1-5 MVME6100 Connectors
Connector Function
J3 IPMC761/712 connector
J4 PMC expansion connector
J9, J93 Gigabit Ethernet connectors
J11, J12, J13, J14 PCI mezzanine card (PMC) slot 1 connector
J19 COM1 connector
J21, J22, J23, J24 PCI mezzanine card (PMC) slot 2 connector
J29 COM2 planar connector
P1, P2 VME rear panel connectors