Artesyn MVME6100 Single Board Computer Installation and Use (June 2014) - Manual (Page 105)

Appendix A
MVME6100 Single Board Computer Installation and Use (6806800D58H) 105
A
Specifications
A.1 Power Requirements
In its standard configuration, the MVME6100 requires +5 V, +12 V, and –12 V for operation.
On-board converters supply the processor core voltage, +3.3 V, +1.8 V, and +2.5 V.
A.1.1 Supply Current Requirements
Table A-1 provides an estimate of the typical and maximum current required from each of the
input supply voltages.
In a 3-row chassis, PMC current should be limited to 19.8 watts (total of both PMC slots). In a 5-
row chassis, PMC current should be limited to 46.2 watts (total of both PMC slots).
A.2 Environmental Specifications
Table A-2 lists the environmental specifications, along with the board dimensions.
Table A-1 Power Requirements
Model Power
MVME6100-0163 Typical: 42W @ +5 V
Maximum: 51W@ +5 V
MVME6100-0163 with IPMC712/761 Typical: 46W @ +5 V
Maximum: 55W @ +5 V
Table A-2 MVME6100 Specifications
Characteristics Specifications
Operating Temperature 0° to +55° C (32° to 131° F) (forced air cooling required)
400 LFM (linear feet per minute) of forced air cooling is
recommended for operation in the upper temperature range.
Storage Temperature –40° to +85° C (–40° to +185° F)
Relative Humidity Operating: 5% to 90% noncondensing
Non-operating: 5% to 90% noncondensing
Vibration Non-operating: 1 G sine sweep, 5–100 Hz,
horizontal and vertical (NEBS1)