Artesyn MVME6100 Single Board Computer Installation and Use (June 2014) - Manual (Page 51)

MOTLoad Firmware
MVME6100 Single Board Computer Installation and Use (6806800D58H) 51
3.5.5 Deleting VME Settings
To delete the changeable VME setting (restore default value), type the following at the
firmware prompt:
 vmeCfg –d –m
Deletes Master Enable state
 vmeCfg –d –i(0 - 7)
Deletes selected Inbound Window state
 vmeCfg –d –o(0 - 7)
Deletes selected Outbound Window state
 vmeCfg –d –r184
Deletes PCI Miscellaneous Register state
 vmeCfg –d –r188
Deletes Special PCI Target Image Register state
 vmeCfg –d –r400
Deletes Master Control Register state
 vmeCfg –d –r404
Deletes Miscellaneous Control Register state
 vmeCfg –d –r40C
Deletes User AM Codes Register state
 vmeCfg –d –rF70
Deletes VMEbus Register Access Image Control Register state
3.5.6 Restoring Default VME Settings
To restore all of the changeable VME setting back to their default settings, type the following
at the firmware prompt:
vmeCfg –z