Artesyn MVME6100 Single Board Computer Installation and Use (June 2014) - Manual (Page 17)

Chapter 1
MVME6100 Single Board Computer Installation and Use (6806800D58H) 17
Hardware Preparation and Installation
1.1 Overview
This chapter contains the following information:
 Board preparation and installation instructions
 ESD precautionary notes
1.2 Description
The MVME6100 is a single-slot, single-board computer based on the MPC7457 processor, the
MV64360 system controller, the Tsi148 VME Bridge ASIC, up to 1 GB of ECC-protected DDR
DRAM, up to 128MB of flash memory, and a dual Gigabit Ethernet interface.
Front panel connectors on the MVME6100 board include: two RJ-45 connectors for the Gigabit
Ethernet, one RJ-45 connector for the asynchronous serial port with integrated LEDs for
BRDFAIL and CPU run indication, and a combined reset and abort switch.
The MVME6100 is shipped with one additional asynchronous serial port routed to an on-board
header.
The MVME6100 contains two IEEE1386.1 PCI, PCI-X capable mezzanine card slots. The PMC
slots are 64-bit capable and support both front and rear I/O. All I/O pins of PMC slot 1 and 46
I/O pins of PMC slot 2 are routed to the 5-row DIN, P2 connector. I/O pins 1 through 64 from
J14 of PMC slot 1 are routed to row C and row A of P2. I/O pins 1 through 46 from J24 of PMC
slot 2 are routed to row D and row Z of P2.
The MVME6100 has two planar PCI buses (PCI0 and PCI1). In order to support a more generic
PCI bus hierarchy nomenclature, the MV64360 PCI buses will be referred to in this document
as PCI bus 0 (root bridge instance 0, bus 0) and PCI bus 1 (root bridge instance 1, bus 0). PCI bus
1 connects to PMC slots 1 and 2 of the board. PCI bus 0 connects to the Tsi148 VME Bridge ASIC
and PMCspan bridge (PCI6520). This interface operates at PCI-X (133 MHz) speed. Both PCI
planar buses are controlled by the MV64360 system controller.
Voltage Input/Output (VIO) for PCI bus 1 is set by the location of the PMC keying pins; both pins
should be set to designate the same VIO, either +3.3V or +5V.