Artesyn Centellis 2000 Shelf Release 3.0 Installation and Use (May 2014) - Manual (Page 79)

Site Preparation
Centellis 2000 Shelf Release 3.0 Installation and Use (6806800L99G) 79
Additionally, the following mounting options are possible:
 ETSI front and rear mount
 24" rack front mount
 Mid mount
Personal Injury
The system is heavy and improper handling may lead to muscle strain or back injury.
Have two people lift the system or use lifting aids and proper lifting techniques when
handling the system. Do not use the FRU handles to lift the shelf.
Personal Injury or System Damage
A top-heavy rack can topple over, causing damage to equipment and injury to personnel.
If your system is the only one in the rack, make sure to mount the system in the lowest part
of the rack. If several systems are installed in one rack, start with the heaviest component at
the bottom. If the rack is equipped with stabilizing devices, make sure that they are installed
and extended so that the rack is secure. Then proceed to mount or service the system.
Product Damage
During the course of handling, shipping, and assembly, pins, mounting screws, fans and
other items can become loose or damaged.
Do not operate a damaged shelf, this can cause damage to devices that interfere with it.
Grounding
If the product is not properly grounded, it may be damaged by electrostatic discharge.
Make sure that each of the system's parts contact the EMI gasket. The system contains
gaskets at the shelf and module level.
The shelf is also fitted with ESD snaps for the use with conductive wrist straps. Please take
care for proper ESD protection of the operator.