Artesyn Centellis 2000 Shelf Release 3.0 Installation and Use (May 2014) - Manual (Page 101)

Chapter 4
Centellis 2000 Shelf Release 3.0 Installation and Use (6806800L99G) 101
FRU Installation
4.1 Overview
The following chapters help you to start up and maintain the system:
4.2 Installing and Removing RTMs and Blades
The installation and removal procedures of AdvancedTCA blades and RTMs depend on the type
of blade or RTM. For a description of these procedures, refer to the documentation of the
respective blade or RTM.
Step Description
Installing and Removing RTMs and Blades
on page 101
This section provides information about how to install and
remove RTMs and AdvancedTCA blades.
Replacing the Shelf Manager and Hub
Board
on page 102
This section provides information about how to replace
shelf manager and hub boards.
Covering Unused Slots on page 105 This section provides information on covering empty slots.
Replacing AC Power Supply Units on page
105
This section provides information about how to install and
remove AC Power Supply Units.
Replacing DC Power Entry Modules on
page 108
This section provides information about how to install and
remove DC Power Entry Modules.
Installing Circuit Breaker Cover for DC
PEMs
on page 112
This section provides information about how to install the
circuit breaker cover.
Replacing Fan Trays on page 114 This section provides information about how to install and
remove the fan trays.
Maintaining Air Filters on page 120 This section provides information about how to install and
remove air filters.
The system will ship with a filler blade installed into unpopulated AdvancedTCA slots. You
have to remove the filler blade before installing AdvancedTCA blades.