Artesyn Centellis 2000 Shelf Release 3.0 Installation and Use (May 2014) - Manual (Page 13)

Centellis 2000 Shelf Release 3.0 Installation and Use (6806800L99G) 13
About this Manual
Overview of Contents
This Installation and Use manual is organized as follows:
Chapter Description
About this Manual Lists all conventions and abbreviations used in this manual and
outlines the revision history
Safety Notes Describes the safety information which has to be regarded
Sicherheitshinweise Translation of the chapter "Safety Information" to German
System Overview Provides an overview of the features of the system and lists order
numbers
Site Preparation Provides site planning considerations and checklists, describes the
requirements and conditions
System Installation Describes how to install and run the system
FRU Installation Describes how to install and replace blades, RTMs, shelf manager &
hub boards, power components, fan trays and air filters
Non-Field-Replaceable Units Describes the backplane, the alarm panel and the power inlet
Cooling Subsystem Contains information on fans and fan trays
Power Subsystem Contains information on power supplies and power distribution
Network Management and
System Access Contains information on which component can be accessed via
which interface and information on the various addresses you need
to access system components
DHCP Configuration and
Network Boot Contains information on preparing a TFTP server and a DHCP server
and describes how to boot the blades from a TFTP server via network
Redundancy Contains information on cold standby, dual star network topology
and actions of shelf manager and system manager during
switchover, takeover, failover, insertion, and extraction
Software Provides information that you need after you have successfully
installed the hardware
Troubleshooting This chapter helps you to solve problems which may occur
Related Documentation Lists related documentation and specifications