Artesyn Centellis 2000 Shelf Release 3.0 Installation and Use (May 2014) - Manual (Page 163)

Network Management and System Access
Centellis 2000 Shelf Release 3.0 Installation and Use (6806800L99G) 163
BP_B_DHCP_SERVER=
 Backplane Bonding Mode
The backplane interfaces can be a part of a bonding interface if the BP_BOND_MODE
variable is set to either dhcp or static. The bonding interface is named bond0.
Use the following parameters to the BP_BOND_MODE variable to define the configuration
for backplane bonding mode.
none - Do not configure the bonding interface (default)
dhcp - Obtain an IP address for the interface via DHCP
static - Use other parameters to configure the interface
BP_BOND_MODE=none
– Static Configuration of the Backplane Bonding Interface
If using the static parameter to configure the backplane bonding interface, specify
the desired IP address and netmask using the following variables:
BP_BOND_IPADDR=
BP_BOND_NETMASK=
 Default Route (Gateway)
A default route can be configured using the GATEWAY_MODE variable.
Use the following parameters to the GATEWAY_MODE variable to define the configuration
for the route.
none - Do not configure the default route
auto - Automatic configuration of the router
static - Use other parameters to configure the router
GATEWAY_MODE=auto
– Static Configuration of the Default Route
If using the static parameter to configure the default route, specify the desired
router IP address using the following variable: