Artesyn Centellis 2000 Shelf Release 3.0 Installation and Use (May 2014) - Manual (Page 24)

Centellis 2000 Shelf Release 3.0 Installation and Use (6806800L99G)
Safety Notes
24
Personal Injury or System Damage (For DC)
The system is supplied by a TNV-2 voltage. This voltage is considered hazardous. Make sure
that the power supply meets the relevant safety standards.
Ensure that TNV-2 is separated from dangerous voltages (mains) through double or reinforced
insulation.
Personal Injury or System Damage
A top-heavy rack can topple over, causing damage to equipment and injury to personnel.
If your system is the only one in the rack, make sure to mount the system in the lowest part of
the rack. If several systems are installed in one rack, start with the heaviest component at the
bottom. If the rack is equipped with stabilizing devices, make sure that they are installed and
extended so that the rack is secure. Then proceed to mount or service the system.
Personal Injury or System Damage
When pulling the system out of the rack, it can fall down and cause injuries.
Pull out the system cautiously.
Personal Injury
The system is heavy and improper handling may lead to muscle strain or back injury.
Have two people lift the system or use lifting aids and proper lifting techniques when handling
the system. Do not use the FRU handles to lift the shelf.
System Damage
During the course of handling, shipping, and assembly, pins, mounting screws, fans and other
items can become loose or damaged.
Do not operate a damaged shelf, this can cause damage to devices that interfere with it.
Personal Injury
High leakage current can be hazardous and cause injury.