CIRCUTOR PowerStudio Series - Manual (Page 222)

PowerStudio PowerStudio
222 User Manual
exceeded and will finish when it is lower than the value defined by the difference between the
threshold and the hysteresis.
• Gap threshold: Serves to program the gap detection. Each semi-cycle with an rms value not
reaching this defined value will be understood as a gap.
• Gap Hysteresis: Will define a gap hysteresis so that the initial voltage is different to the end of
gap voltage. A gap will start when the voltage does not exceed the threshold value and will
finish when this is lower than the value defined by the sum of the threshold and the hysteresis.
• Interruption threshold: defined as power off (absence of voltage, interruption) the voltage
drops below the value set.
• Interruption hysteresis: An interruption hysteresis is when the start-up voltage is different
from the voltage interruption end. An interruption will begin when the voltage does not exceed
the threshold value and ends when it exceeds the value defined by the sum of the threshold
and hysteresis interruption.
• Minimum frequency: Minimum frequency configured from a device generated event.
• Maximum frequency: Maximum frequency configured from a device generated event.