BINDER KB 23 - Manual (Page 61)

KB (E3.1 + E5.1) 11/2014 page 61/100
2. Entering the time program to the program editor
Program table for the example program:
Section
SEC
Temperature
set-point
[ °C]
TEMP
Section length
[hh.mm]
TIME
Fan speed
[%]
FAN
Operation lines
O.LINE
S01 20 119:59 100 000
S02 20 000:01 100 000
S03 5 047:59 100 000
S04 5 000:01 100 000
In this example the program will be entered to the first program place (P01).
Normal display
Press key
for 5 sec.
Display 1 shows e.g. 0000
Display 2 shows PROGRAM EDITOR (you are in the program editor)
Press program key
Display 1 shows 0000
Display 2 shows UserCod? 0000 (enter user code)
Enter user code using arrow keys e.g. 0001
(basic setting, adjustable in the user level,
chap. 10).
Value is shown in both displays.
Automatically forward after 2 sec.
Display 1 shows 01 program P01 selected
Display 2 shows
alternating
---:--- PRG. program can be selected
CONTINUE X/W (information: to 1 st program section with X/W)
Select program P01 using arrow keys Value is shown in Display 1.
Press key
In the selected program P01 the first program section S01 is shown:
Display 1 shows 01 section S01 has been selected
Display 2 shows
alternating
P01: --- SEC.
enter new set-points for the individual variables with button
X/W.
CONTINUE X/W
or
NEW SEC. X/W
Select section S01using arrow keys
Press key
Display 1 shows 20.0 C (actual temperature set-point)
Display 2 shows
alternating
S01: TEMP 20.0 (variable: temperature in °C)
CONTINUE X/W (information: go on with X/W)
Entry of temperature set-point of 20 °C
using arrow keys